Utilitech 7115-02-BN Manual page 10

EXISTING CONSTRUCTION INSTALLATION INSTRUCTIONS (Continued)
7. Pull the house wires through the hole in the wiring
box cover. Using the quick connectors, connect the
house wiring from the wall switch to the fan housing
(A). 14 AWG is the smallest conductor that should be
used for branch-circuit wiring. Please refer to the wiring
diagrams on page 4 to ensure proper wire connections
are made.
Carefully push the wire connections into the wiring box
housing and reattach the wiring box cover.
CAUTION: If your electrical wires do not match the
colors listed, consult a licensed electrician to determine
what each house wire represents before connecting
the fan.
8. Connect a 4 in. circular duct to the duct connector on
the fan housing (A), securing it with duct tape or a
clamp. Vent the duct to the outside.
9. With the wiring and duct connected, insert the fan
housing (A) into the ceiling hole. Position the fan
housing (A) so the bottom edge of the fan housing (A)
is flush with the ceiling board.
7
8
4 in. duct
9
10
Quick connector
Wiring
box
cover
Wiring
box
cover
Duct tape
or clamp
A
A
Ceiling