Cub Cadet 1345 SWE Operator's Manual page 13

Lube Under Chute Base
Figure 14
Discharge Chute
The base of the discharge chute and the spirals on the
chute crank should be lubricated at least every 25
hours of use. When applying the lubrication, apply the
lubricant as shown in Figure 14 to the point under the
base of the chute and where the spirals contact the
discharge chute.
Drive and Shifting Mechanism
At least once a season or after every 25 hours of
operation, remove rear cover. Lubricate any chains,
sprockets, gears, bearings, shafts, and the shifting
mechanism at least once a season. Refer to Figure 11.
Use engine oil or a spray lubricant. Avoid getting oil on
rubber friction wheel and aluminum drive plate.
Gear Case
The gear case is lubricated with grease at the factory
and does not require initial checking. If disassembled
for any reason, lubricate with two ounces of Shell
Alvania™ grease EPR00, part number 737-0168.
Before reassembling, remove old sealant and apply
Loctite™ 5699 or equivalent.
To check the level of grease in the gear case, remove
the vent plug as shown in Figure 13. If necessary, add
grease using a grease gun and the grease fitting on the
side of the gear case.
Do not overfill the gear case. Be sure the
IMPORTANT:
vent plug is free of grease in order to relieve pressure.
Auger Bearings and Shaft
Every season lubricate the auger bearings and the
bearings on the side of the frame with light oil. Refer to
Figure 13.
Use oil or spray lubricant into the bearings at the
wheels at least once a season. Remove the wheels,
one side at a time, and clean and coat axles with multi-
purpose automotive grease.
Lubricate the auger shaft at least once a season. To do
this:
Chute Crank Spirals
13
• Remove the shear bolts on the auger shaft.
• Oil or spray lubricant inside shaft.
• Carefully spin the auger around by hand to
disperse the lubricant.
• Reinstall the shear bolts.
Traction Control / Auger Control Lock
The cams on the ends of the control rods which
interlock the traction drive and auger drive clutches
must be lubricated at least once a season or every 25
hours of operation using a multi-purpose automotive
grease. The cams can be accessed beneath the handle
panel as shown in Figure 15.
Control Rods
Figure 15
Check V-Belts
Follow the instructions below to check the condition of
the drive belts every 50 hours of operation.
• Remove the plastic belt cover on the front of the
engine by removing the three self-tapping screws.
• Visually inspect for frayed, cracked, or excessively
worn out belts.
• Replace belts as necessary as outlined in Section
7.
Check Friction Wheel Rubber
Follow the instructions below to check the condition of
the friction wheel rubber every 25 hours of operation.
• Remove the six self-tapping screws from the frame
cover underneath the snow thrower.
• Visually inspect the friction wheel rubber for
excessive wear, cracks, or loose fit on the friction
wheel drive hub.
• Also engage the traction control and check if the
friction wheel is making contact with the friction
plate.
• If it does not make contact, adjust the traction drive
cable following instructions and recheck the friction
wheel.
• Replace friction wheel rubber if necessary. Refer to
instructions in Section 7.
Handle Panel
Lube Cams Here