Panasonic AUTO-LOGIC KX-T4330 Service Manual And Technical Manual page 7

With the base unit
a
[ car] © in Pace &
To hang up, press the TALK button or
place the portable handset on the base
unit.
—The TALK indicator light goes out.
Make sure that the RINGER selector is set to "HIGH" or "LOW", or the
base unit will not ring.
{| oa
MUTE
MEMO
co WAY REC
PAGE/NTERCOM
we 000
MEMO
RRWAY REC
When the telephone rings, press the
SP-PHONE button to answer the call.
—The SP-PHONE indicator light is on.
Speak into the MIC (microphone).
—Adjust the speaker volume using the
VOLUME control on the right side.
To hang up, press the SP-PHONE
button.
—The SP-PHONE indicator light goes
out.
KX-T4330
C7) (x2) Ge3)
SOREPEAT ==SKIP --RESET
NEWMSG ALLMSG ROOM
SsTorP
C4)
ANS OFF ANSON
(ene) Grex} (_#)
ANS OFF ANSON
[SCREEN PLAYBACK
STREPEAT —s3SKIP RESET
NEWMSG —ALLMSG
Gone} (oven) (_¥)
ANS OFF ANS ON
Press one of the dialing buttons
(0 through 9) to select the memory
station.
—The phone number is stored in that
memory location.
—To store other numbers, repeat
steps 1 through 4.
Dialing a stored number from memory
Press the TALK button to get dial tone.
—The TALK indicator light is on.
'
Press the AUTO button.
Press the dialing button (0 through 9)
where the phone number you want to
dial is stored.
—The stored number is dialed
automatically.
INTERCOM
You can use the portable handset and the base unit as a 2-way intercom. AUTOMATIC DIALING
Paging the base unit from the portable handset
Storing phone numbers in memory
The dialing buttons (0 through 9) function as memory stations for
automatic dialing. A 16-digit phone number can be stored in each station.
Gare aarriowO
MEMO?WAY
NEWMSG "ALLMSG ROG)
'STO
(ove) Gen) C_#)
ANS OFF ANS ON
(one) foren0} C4)
ANS OFF "ANS ON
>
(one) e9} C_4)
ANS OFF ANS ON
CURR ear c0.m O-( PROG)
Press the PROG button to switch the
unit to the programming mode.
—The BATT LOW indicator light is on.
Enter a phone number up to 16 digits.
Press the AUTO button.
PAGEANTERCOM
me 00
> SREPEAT
NEW MSG
The portable handset user:
Press the INT'/PAGE button.
—Both units beep while the
INT/PAGE button is pressed. When
you release it, the unit automatically
switches to the intercom mode. If
there is no answer, press the
INT'/PAGE button again to end the
intercom.
The base unit user:
When the unit beeps and the paging
party's voice is heard, answer through
the MIC (microphone).
The portabie handset user:
When the conversation is over, press
the INT'/PAGE button.
—Intercom calls can only be
terminated by the portable handset.