Dell 7HT3R Installation And Service Manual page 84

Figure 74. Installing the Riser 2a
3. For Riser 2b, re-connect the cable from the system board, then release the blue latch and holding the touch points, align
the expansion card riser with the connector and the riser guide pin on the system board. Lower the expansion card riser into
place until the expansion card riser connector is fully seated in the connector.
Figure 75. Installing the Riser 2b with SNAPI module
4. For Riser 2c, release the blue latch and holding the touch points, align the expansion card riser with the connector and the
riser guide pin on the system board. Lower the expansion card riser into place until the expansion card riser connector is fully
seated in the connector.
84 Installing and removing system components