Denon DVD-5000 Service Manual page 13

3-1. Replacing the Laser Pick-Up
1. Remove the 2 screws.
2. Remove the Laser Pick-Up.
Fig. 3-1 Replacement of the Laser Pick-up
3-2. Replacing the Traverse Motor
Unit
1. After the Laser Pick-Up has been removed, remove the 2
screws.
2. Remove the Traverse Motor Unit.
Traverse Motor Unit
Fig. 3-2 Replacement of the Traverse Motor Unit
3-3. Replacing the Disc Motor
1. This disc motor can be removed after the Traverse Unit
has been separated into two sections.
2. Remove the 2 screws A.
3. Remove the 2 screws B using an Hex. wrench.
Use an Hex. wrench to remove B.
Fig. 3-3 Replacement of the Disc Motor
Note: It is not necessary to remove the Laser Pick-Up for
replacement of the Disc Motor.
3-4. Disc Motor Assembly/Tentative
Tilt Adjustment
1. For the Disc Motor assembling, install the 2 Screw B
(adjustment screw) after firmly tightening the 2 Screws A.
(Refer to the figure 3-3.)
2. Use the 2 Screws B to temporarily set the Disc Motor so
that it rests parallel to the Base.
Fig. 3-4 Disc Motor Assembling
3. For final adjustment, proceed the Titt Adjustment of Disc
Motor (Page 2-12).
3-5. Others
1. Reassemble the Laser Pick-Up and the Traverse Motor Unit
in precisely the reverse order as they were disassembled.
2. After reassemble the Laser Pick-up and the Traverse Motor
Unit, perform the Tilt Adjustment of Disc Motor (Page
2-12).
DVD-5000 Ha
13 i
1
j
'