Audio Connections - Headphones And External Equipment; Connecting A Footswitch; Turn On The Power; Using The Music Rest - Yamaha PSR-E323 Owner's Manual

Make all necessary connections BEFORE turning the power on.
Audio Connections —
Headphones and External Equipment
You can connect the PHONES/OUTPUT jack to a set
of headphones, keyboard amplifier, stereo system,
mixer, tape recorder, or other line-level audio device
to send the instrument's output signal to that device.
The internal speakers are automatically shut off when
a plug is inserted into this jack. The PHONES/OUT-
PUT jack also functions as an external output.
CAUTION
• Avoid listening with the headphones at high volume for
long periods of time; doing so may not only result in ear
fatigue, it may be damaging to your hearing.
CAUTION
• To prevent damage to the speakers, set the volume of the
external devices at the minimum setting and turn power
off the devices before connecting them. Failure to
observe these precautions may result in electric shock or
equipment damage. Also, be sure to set the volumes of all
devices at their minimum levels and gradually raise the
volume controls while playing the instrument to set the
desired listening level.

Connecting a footswitch

The sustain function lets you produce a natural sustain
as you play by pressing an optional footswitch. Plug
the Yamaha FC4 or FC5 footswitch into the SUSTAIN
jack and use it to switch sustain on and off.
NOTE
• Make sure that the footswitch plug is properly connected to
the SUSTAIN jack before turning on the power.
• Do not press the footswitch while turning the power on. Doing
this changes the recognized polarity of the footswitch, result-
ing in reversed footswitch operation.

Turn on the power

Turn down the volume by turning the [MASTER
VOLUME] control to the left and press the
[STANDBY/ON] switch to turn on the power. While
playing the keyboard, adjust the volume level by using
the [MASTER VOLUME] control. Pressing the
[STANDBY/ON] switch again turns the power off.
CAUTION
• When using a power adaptor, even when the power is off,
a small amount of electricity is still being consumed by
the instrument. When you are not using the instrument for
a long time, make sure to unplug the AC power adaptor
from the wall AC outlet, and/or remove the batteries from
the instrument.

Using the music rest

Removing the protective film
Remove the transparent protective film that was
applied to the display prior to shipment from the fac-
tory.
PSR-E323/YPT-320 Owner's Manual
Setting Up
Insert the music
rest into the slots
as shown.
9