GENERAL POWER TOOL • Remove any adjusting key or wrench before turning the power tool on. A wrench or a key left SAFETY WARNINGS attached to a rotating part of the power tool may Read all safety warnings, instruc- WARNING result in personal injury.
Page 3
Maintain labels and nameplates. These carry Do not use a battery pack or tool that is • important information. If unreadable or missing, damaged or modified. Damaged or modified contact a MILWAUKEE service facility for a ® batteries may exhibit unpredictable behaviour replacement.
ASSEMBLY SPECIFICATIONS Recharge only with the charger Volts ............18 V DC WARNING specified for the battery. For Battery Type ..........M18™ specific charging instructions, read Charger Type ..........M18™ operator’s manual supplied with your charger 1.3 kg Weight ............and battery. (Tool-Only) Inserting/Removing the Battery Recommended Ambient To insert the battery, slide the pack into the body of...
Selecting Speed OPERATION To reduce the risk of injury, WARNING Mode always wear proper 0-1,125 0-1,650 protection marked to comply with AS/NZS 1337.1. 0-1,525 0-2,475 Using the Drive Control The drive control button is used to adjust the torque, 0-1,850 0-3,000 rotation speed (RPM), and impact speed (IPM) for 0-2,325...
Return the tool, battery pack, and charger to a MILWAUKEE service facility for ® repair. If the tool does not start or operate at full power with a fully charged battery pack, clean the contacts on the battery pack.
Page 8
Australia and New Zealand. SERVICE - AUSTRALIA and NEW ZEALAND MILWAUKEE ® prides itself in producing a premium quality product that is Nothing But Heavy Duty Your satisfaction with our products is very important to us! If you encounter any problems with the operation of this tool, please contact your authorised MILWAUKEE ®...