Samson C01U Owner's Manual page 15

CO1U - USB Studio Condenser Microphone a
Using the Optional SP01 Shock-Mount
For additional isolation the CO1U can
be fitted on the optional SP01 "Spider"
shock mount. Follow the steps below
the to install the SP01.
oe
XX
0°,
2
Xs
?, >
° First, screw the SP01 shock
mount onto your mic stand or
boom arm. If you're using a US
5/8" mic stand or boom, remove
the Euro adapter.
° Remove the C01U swivel mount
by rotating the threaded collar
counterclockwise as shown in
figure 1.
° Install the CO1U into the SP01
by fitting the microphone into
the center of the web, position-
ing the CO1U onto the bottom
mounting plate.
THREADED
COLLAR
° Secure the SP01 by reinstalling
the threaded collar, rotating
clockwise until tight. (Figure 2)
b>
Kose
C Now, loosen the thumb screw
to adjust the angle of the micro-
phone and position the CO1U SP01
to the desired location. Once SS SHOCK MOUNT
set, tighten the thumbscrew to
secure the microphone in place.
Note: Be careful not to cross
thread or over tighten the thread-
ed collar or thumb screw.
\°)
Z
=
=
=
Cees
THREADED
COLLAR
13