HoMedics CMTF91 Instruction Manual And Warranty Information page 6

TO FILL WITH A PITCHER
1. Before filling with water
for the first time, remove
1 demineralization
cartridge from the
packaging and soak in
water for 10 minutes.
3. Fill with clean, cool water or distilled water (if
in area with hard water) until the water level
reaches the MAX fill line. DO NOT fill with warm
or hot water. CAUTION: Never add essential
oils or other additives to the water tank or
water reservoir. Refer to the section on how to
properly use essential oils with this humidifier.
4. Add the soaked
demineralization
cartridge to the water
tank.
ABOUT WHITE DUST
Use of high mineral content hard water may cause a white mineral residue to accumulate on surfaces
in the room near the humidifier. The mineral residue is commonly called "white dust." The higher the
mineral content (or, the harder your water is), the greater the potential for white dust. The white dust
is not caused by a defect in the humidifier. It is caused only by minerals suspended in the water.
2. Remove the tank
cover.
MAX
5. Replace the tank
cover.
TO FILL AT THE FAUCET
1. Before filling with water
for the first time, remove
1 demineralization
cartridge from the
packaging and soak in
water for 10 minutes.
3. Use 2 hands to carry the water tank. Fill with
clean, cool water or distilled water (if in area
with hard water) until the water level reaches the
MAX fill line. DO NOT fill with warm or hot water.
CAUTION: Never add essential oils or other
additives to the water tank or water reservoir.
Refer to the section on how to properly use
essential oils with this humidifier.
4. Add the soaked
demineralization
cartridge to the
water tank.
6
2. Remove the tank
cover and water
tank.
MAX
5. 5. Reassemble making
sure all parts are firmly
seated.