Table of Contents
Advertisement
en-us Appliance care
16.1 Overview of the basic settings
Program selector with program positions
Set the volume of the signal tone that is emitted
1
when the program ends:
0 (off) to 4 (very loud)
Set the volume of the signal tone that is emitted
2
when the buttons are selected:
0 (off) to 4 (very loud)
Set the display brightness:
3
1 (low) to 4 (very high)
Adjust the dryness level → Page 21 :
4
0 (dry) to 3 (driest)
Start the basic (CP1) or intensive (CP2) appliance
5
care program.
→ "Appliance care", Page 30
Display the number of started programs.
6
Restore the appliance to the factory settings (rES).
7
16.2 Changing the basic settings
To call up the basic settings, press Basic Settings.
1.
Select the required basic setting.
2.
→ "Overview of the basic settings", Page 30
Adjust the basic setting:
3.
To change the value, press
‒
To reset the appliance to the factory settings, press
‒
and hold
for approx. 3 seconds.
Press Basic Settings to save the settings.
4.
30
1
2
3
4
5
6
7
or
.
17 Appliance care
Appliance care
The appliance offers cleaning programs for basic and
Appliance care
intensive appliance care.
17.1 Preparing for the appliance care
program
Preparing the appliance for the appliance care
program
Prepare the appliance before running the appliance care
program.
Requirements
¡ The drum is empty.
¡ The appliance is in standby mode.
Clean the lint screen. → Page 25
1.
Pull out the condensation container horizontally and
2.
empty it. → Page 26
Preparing the condensation container for the
appliance care program
If you are draining the condensation water from the
appliance using the drain hose, prepare the condensation
container before running the appliance care program.
Remove the stopper from the recess in the top
1.
insert it in the underside
When the appliance is delivered, the stopper is included
as an accessory in the scope of delivery.
Clean the filter in the condensation container.
2.
17.2 Calling up the appliance care program
Requirement: The appliance care program is ready.
→ Page 30
Press .
1.
The switch-on process takes a few seconds.
Press Basic Settings.
2.
Set the program to position 5.
3.
a "CP1" and the program duration alternate on the
display.
and
.
Advertisement
Table of Contents
