Adjustment / Alignment Procedure
1. Preparation :
(1) Setup input timing SVGA2(38.879K, 60.317Hz) & 32-Grays pattern.
(2) Enter factory OSD.
(3) Enter the Auto Turn on mode.
(4) Power off the monitor, then power on again.
(5) Setup unit and keep it warm up at least 1hour.
(6) Backlight should set to " Bright ".
2. PC Auto Timing Check :
(1) Timing list :
Resolution
720*400
640×480
800×600
1024×768
(2) Setup input timing SVGA2(38.879K, 60.317Hz) "16-Grays pattern" pattern.
(3) Select timing from above timing list.
(4) If position is wrong, press "Auto Adjustment" function at factory OSD to check this
function
3. PC(RGB) ADC Calibration :
(1) Setup input timing SVGA2(38.879K, 60.317Hz) & 16-Grays pattern to DSUB connector.
(2) Steup "source" to "PC".
(3) Select 16:9 format
(4) Enter factory OSD
(5) Enter the "ADC CAL...." page and run "Calibration" function
(6) Execute "Input 16 grays scale pattern for PC" to start calibration.
Horizontal
Vertical
Frequency(Khz)
Frequency(Hz)
31.47
31.50
37.90
48.40
Dot Clock
Frequency(Mhz)
70.08
28.322
60.00
25.18
60.32
40.00
60.00
65.00
90
Remark
DOS
DOS
VESA
VESA