Set Point Control Settings - Excell FJ5 Service Manual

EXCELL PRECISION CO., LTD.

2-1-3 Set Point Control Settings

 The set point control function is disable when the weight value is set to "0" in the set point
control setting.
Press key
TARE
Enter the desired set
point (weight value)
.
Press key
TARE
Set point control:
When the weighing value of an object exceeds the value of set point control, the
crane will beep continuously.
When the value of set point control is set as 0, the function of set point control is
disabled.
The value of set point control cannot exceed the maximum capacity of the crane
scale.
When the weight of an object is lighter than set point control value, press
key manually and the crane will be held in HOLD function. Under the HOLD
function even if you add the additional weights to exceed the set point control
value, the crane will not start set point control function.
45046
LCD displays the current configuration
Default setting = 0
.
MODE  Upward digit selecting (0-9)
HOLD  Downward digit selecting (9-0)
ZE RO  Move the cursor rightward
TA RE  Confirm
15
HOLD
ZSME300000343