Disassembly Procedures - JVC DR-E34BK Service Manual

DR-E34BK
DR-E34LBK
Disassembly Procedures
(1) Removing the top cover
1. Remove the screws on both sides of the
cassette receiver.
2. Remove the four screws on the back, then
lift up the back of the top cover.
(2) Removing the front panel
1. Remove two screws fastening the side of
the front panel assembly, and five black
screws fastening the bottom.
2. Disconnect the connectors.
Main
P.C.Board(*J021,*J261,*J251,*J041,P201,
P202,JB301)
TUNER P.C. Board (J101),( J105 only A ,U)
*Notes : When removing the flat wire from
the connector,press the connector
lock as shown in. (Fig 1)
(3) Removing the cassette mechanism
1. Remove the screws @ and the screws @.
Screws ® are the double line screws for
plastic screws.
Screws © are the tapping screws for
chassis.(Fig 2)
2. Open the cassette door and remove the
mechanism
(4) Removing the cassette door
1. Remove the cassette mechanism.
2. Disconnect the cassette spring from the
Holder bracket.
3. Remove the screws @ folding the damper
units and then remove the damper units.
4. Remove the screws @ and then remove the
Holder Bracket.(Fig 3)
(5) Removing the cassette switch P.C. Board
1. Remove the cassette doors.
2. Remove the six screws holding the cassette
switch P.C. Board.
3. Remove the cassette switch P.C. Board.
(6) Removing the Front P.C. Board
1. Remove the balance volume knob and the
master volume.
2. Remove the flat wire FW451.
3. Remove the fourteen screws ©. (Fig 4)
4. Remove the Front P.C. Board.
(7) Removing the Master volume
1. Pull off the master volume knob.
2. Remove the nut fixing the master volume.