Kenwood DNX7120 Instruction Manual page 97

Some functions ofthis unit m ay b e disabled by
some settings made on this unit.
•Cannot set u p
the subwoofer.
• Cannot set up subwoofer phase.
• No output from the subwoofer.
• Cannot set up the low pass filter.
• Cannot set up the high pass filter.
• Subvvoofer is not set to On. _,', <Audio Setup>
(page 62)
• The Dual zone function is enabled. _,', <Zone
Control> (page 88)
_]_ Cannot set up the subwoofer phase.
• Subwoofer is not set to On. _', <Audio Setup>
(page 62)
• Low pass filter is set toThrough. _', <Crossover
Network Setup> (page 63)
_[_ • Cannot select the output destination of the
subsource in the Dual zone.
• Cannot adjust the volume of the rear
speakers.
• Tile Dual zone function is disabled. ,:. <Zone
Control> (page 88)
_[_ Cannot play audio files.
• "CD Read" of <System Setup> (page 66) is set
to "2".
Cannot Folder select.
• Tile Scan play or Random play function is
enabled.
Tuner source
Radio reception is poor.
v' Tile car antenna is not extended.
_,', Pull the antenna out all the way.
v' The antenna control wire is not connected.
_,', Connect the wire correctly, referring to the
section on <INSTALLATION MANUAL>.
Disc source
The specified disc does not play, but another
one plays instead.
v' Tile specified CD is quite dirty.
_,', Clean the CD.
v' The disc is loaded in a different slot from that
specified.
_:, Eject the disc magazine and check the
number for the specified disc.
v' The disc is severely scratched.
_,', Try another disc instead.
Audio file source
The sound skips when an Audio file is being
played.
v' Tile media is scratched or dirty.
_,', Clean the media, referring to the CD
cleaning of the section on <Handling discs>
(page 6).
v' The recording condition is bad.
_,', Record the media again or use another
media.
_1_ Cannot perform Repeat play.
• The PBC function is enabled.
• Cannot set up the equalizer.
• Cannot set up the crossover network.
• Tile Dual zone function is enabled. _,', <Zone
Control> (page 88)
What might seem to be a malfunction in your unit
may just be the result of slight misoperation or
miswiring. Before calling service, first check the
following table for possible problems.
Navigation
The touch panel control of the navigation
system does not work.
v' Navigation software is not the latest version.
_,', Update the navigation software. For how to
update the software, refer to the instruction
manual of the navigation unit.
General
The Touch Sensor Tone doesn't sound.
v' Tile preout jack is being used.
_,', The Touch Sensor Tone can't be output from
the preout jack.
English _ 97