Woods BW10.52 Operator's Manual page 33

Check Gearbox
1. Apply Permatex
equivalent sealant to top of housing. Place top cover
(21) on housing and secure into position using six
cap screws (20).
2. Check gearbox for leaks by: plugging all holes ex-
cept one, applying 4 psi of compressed air, and
immersing gearbox in water. Verify gearbox does
not leak.
NOTE: Excessive air pressure will damage seals.
3. Remove gearbox from water and dry off.
4. Remove upper plug (3) on right side of housing. Add
SAE 80W or 90W (API GL-4 or GL-5) gear lube until
it runs out side level hole. Replace plug.
5. Install breather (18) in top cover.
1. Shaft 1-3/4, 20 spline, wing
2. Oil seal
3. 3/8 plug
4. Snap ring
5. Bearing
6. Pinion gear
7. Bearing
8. Shim
9. Housing
10. Snap ring
11. Oil seal
12. Shim
13. Bearing
14. Shaft 1-3/4, 20 spline, center
15. Snap ring
16. Bearing
17. Gear
18. 1/2 Breather
19. 5/16 Lock washer
20. M8 x 30 Cap screw 8.8
21. Cover
22. Snap ring
MAN1352
( 01/18/2024 )
MAN1352_2024-01.indd 33 MAN1352_2024-01.indd 33
Aviation 3D Form-A-Gasket or
®
10
12
11
Figure 13. Splitter Gearbox Assembly
Reinstallation on Cutter
■ Gearboxes are heavy and can cause muscle
strain or back injury. Use lifting aids and proper
lifting techniques when handling.
1. Place gearbox on cutter and secure into position
using four cap screws and lock washers.
2. Torque hardware to 300 lbs-ft.
3. Attach all drivelines to gearbox.
4. Install all shields.
19
21
CD6143A-1
14
15
16
17
Dealer Service 33
WARNING
20
18
10
12
13
9
8
7
6
1
22
5
8
4
2
11
1/19/24 1:05 PM 1/19/24 1:05 PM