Adding Fuel - Toro 74676 Operator's Manual

Table of Contents

Advertisement

containers on the ground, away from your vehicle
before filling.
Remove the equipment from the truck or trailer
and refuel it while it is on the ground. If this is not
possible, then refuel from a portable container
rather than a fuel-dispenser nozzle.
Do not operate the machine without the entire
exhaust system in place and in proper working
condition.
Keep the fuel-dispenser nozzle in contact with
the rim of the fuel tank or container opening at
all times until fueling is complete. Do not use a
nozzle lock-open device.
If you spill fuel on your clothing, change your
clothing immediately. Wipe up any fuel that spills.
Never overfill the fuel tank. Replace the fuel cap
and tighten it securely.
Store fuel in an approved container and keep it
out of the reach of children. Never buy more than
a 30-day supply of fuel.
Do not fill the fuel tank completely full. Add fuel to
the fuel tank until the level is 6 to 13 mm (1/4 to
1/2 inch) below the bottom of the filler neck. This
empty space in the tank allows fuel to expand.
– Avoid prolonged breathing of vapors.
– Keep your face away from the nozzle and fuel
tank opening.
– Avoid contact with skin; wash off spills with
soap and water.

Adding Fuel

Recommended Fuel
For best results, use only clean, fresh (less than
30 days old), unleaded gasoline with an octane
rating of 87 or higher ((R+M)/2 rating method).
Ethanol: Gasoline with up to 10% ethanol
(gasohol) or 15% MTBE (methyl tertiary butyl
ether) by volume is acceptable. Ethanol and
MTBE are not the same. Gasoline with 15%
ethanol (E15) by volume is not approved for use.
Never use gasoline that contains more than
10% ethanol by volume, such as E15 (contains
15% ethanol), E20 (contains 20% ethanol), or E85
(contains up to 85% ethanol). Using unapproved
gasoline may cause performance problems and/or
engine damage which may not be covered under
warranty.
Do not use gasoline containing methanol.
Do not store fuel either in the fuel tank or fuel
containers over the winter unless you use a fuel
stabilizer.
Do not add oil to gasoline.
Using Stabilizer/Conditioner
Use a fuel stabilizer/conditioner in the machine to
provide the following benefits:
Keeps fuel fresh during storage of 90 days or less
(drain the fuel tank when storing the machine for
more than 90 days)
Cleans the engine while it runs
Eliminates gum-like varnish buildup in the fuel
system, which causes hard starting
Important:
Do not use fuel additives
containing methanol or ethanol.
Add the correct amount of fuel stabilizer/conditioner
to the fuel.
Note:
A fuel stabilizer/conditioner is most
effective when mixed with fresh fuel. To minimize
the chance of varnish deposits in the fuel system,
use fuel stabilizer at all times.
Filling the Fuel Tank
1.
Park the machine on a level surface.
2.
Engage the parking brake.
3.
Shut off the engine and remove the key.
4.
Clean around the fuel-tank cap.
5.
Fill the fuel tank to the bottom of the filler neck
(Figure
8).
Note:
Do not fill the fuel tank completely full.
The empty space in the tank allows the fuel to
expand.
15

Advertisement

Table of Contents
loading

This manual is also suitable for:

Timecutter sw 5000Timecutter sw 420074680

Table of Contents