Cub Cadet 3184 Operator's Manual page 41

When reinstalling the blades, be sure
they are installed so that the wind
wings are pointing upward toward the
top of the deck. Tighten the nuts to 90
to 110 ft-lbs. (122 to 149 N·m).
After replacing the blades, apply
grease to the exposed threads at the
bottom of the spindle bolts to prevent
rust buildup.
B. Lubrication
After every 10 hours of operation and/
or before putting the deck into winter
storage, lubricate
assemblies and the spindle belt idler
arm using 251H EP grease or an
1
2&5
1. Belt Covers
2. Button Plugs - Access to
Spindle Lube Fittings
Idler Arm - w/Square Hole
3.
equivalent No. 2 multipurpose lithium
grease. The lube fitting for the outer
spindles can be accessed by removing
the button plugs in the belt covers.
Use grease liberally. Excess grease
will be expelled from the upper spindle
seals.
greased, the expelled grease will
cause the top spindle seal to give off a
muffled crackling noise (Refer to
Figure 48).
Apply grease to all other lube fittings
after every 50 hours of operation.
the spindle
Refer to the MAINTENANCE CHART
and LUBRICATION ILLUSTRATION
in Section 9
4
3
4. Idler Arm Lube Fitting
5. Spindle Assembly Lube
Fitting
6. Gear Box Mounting Bracket
Figure 48
41
When the spindle is fully
6
1
2&5
5