Cub Cadet 3184 Operator's Manual page 23

• Left headlight — appoximately 1/4
turn counterclockwise.
• Right headlight — approximately
1/4 turn clockwise.
3. Push the bulb inward and turn
counterclockwise to remove from
the socket.
4. Align a locking post of the bulb
base with the notch in the socket,
then push the bulb inward and
turn clockwise to lock
5. With the terminals
upward, align the tab of the
socket with the notch of the
reflector. Push the socket inward
and turn as follows to lock:
• Left headlight — appoximately 1/4
turn clockwise.
• Right headlight — approximately
1/4 turn counterclockwise.
6. Connect the wire harness leads to
the appropriate socket terminals.
Tire Inflation
Keep the tires inflated
recommended pressure.
inflation will affect tire life and operator
comfort, and also could affect the level
of the mower deck and quality of cut.
See the tire side wall for proper
inflation range.
Ensure that the valve caps are
securely tightened in place to prevent
air loss and to protect the valve core.
Do not overload the tractor tires by
mounting equipment on the tractor
which exceeds the load capacity of the
size of the tires on the tractor.
Checking Transmission Oil Level
NOTE: Check the oil level only while
the engine is stopped and the tractor
is level.
Check the oil level of the transmission
case before each use to see that it is
filled to the correct level. Before
checking the transmission oil level,
clean the
Transmission
prevent debris from entering the
transmission case. Always keep the oil
level between the "FULL" and the
"ADD" marks on the dipstick. When
checking the oil level, the dipstick
must be withdrawn and wiped clean,
then reinserted all the way before
being withdrawn again for a true
reading.
pointing
F
Operating
Range
A
to the
Improper
Adding Transmission Oil
WARNING: The fluid for your
transmission has been spe-
cially formulated to ensure
the safe and proper opera-
tion of your tractor. Add Cub
Cadet Drive System Fluid
Plus ONLY. Do not use any
other fluid.
WARNING: Never overfill the
transmission case. Damage
may result if the oil level in
the
below the "ADD" mark or
over the "FULL" mark of the
dipstick.
23
area around the
Oil Fill/Dipstick to
Dipstick Reading
Transmission
Oil Fill Tube/
Dipstick
Figure 18
transmission case is