Printing Glossy Paper - Xerox Phaser 7400 User Manual

4. When the control panel prompts you to confirm the type and size of paper in the tray,
select Change setup, and then press the OK button.
a. Select Labels as the paper type, and then press the OK button.
Note: If you are printing on unusually heavy labels, select
information, see Supported Paper and Media
b. Select either Letter SEF
5.
In the printer driver, select Tray 1 as the paper source and/or select Labels as the paper
type.

Printing Glossy Paper

Glossy paper within the weight range 120–160 g/m
should be printed on one side only.
To order paper, transparencies, or other specialty media, contact your local reseller or go to
www.xerox.com/office/supplies.
Guidelines
■ Do not open sealed packages of glossy paper until you are ready to load them into the
printer.
Leave glossy paper in the original wrapper, and leave the packages in the shipping carton
■
until ready to use.
■ Remove all other paper from the tray before loading glossy paper.
■ Load only the amount of glossy paper you are planning to use. Do not leave glossy paper
in the tray when you are finished printing. Reinsert unused glossy paper in the original
wrapper and seal.
■ Rotate stock frequently. Long periods of storage in extreme conditions can cause glossy
paper to curl and jam the printer.
on page 3-3.
or A4 SEF, and then press the OK button.
2
can be printed from Tray 1 (MPT). It
Phaser® 7400 Color Printer
3-42
Printing on Specialty Media
Heavy Labels. For more