Husqvarna DXR 95 Operator's Manual page 122

5. Remove the inspection cover (A).
6. Pull out and turn the valve for caterpillar track
tension ¼ turn counterclockwise to lock it in an open
position (B) and (C). This releases the pressure.
7. Do the procedure that follows on each side of the
product.
a) Push the tension wheel to the center.
b) Remove the caterpillar tracks.
c) Install new caterpillar tracks.
8. Pull out and turn the valve for caterpillar track
tension clockwise and release it into closed position.
9. Install the inspection cover.
10. Start the product and do the automatic caterpillar
track tension. Refer to
track tension (DXR 145, DXR 275, DXR 305, DXR
315) on page 122 .
122
A
To do automatic caterpillar
To do automatic caterpillar track tension (DXR
145, DXR 275, DXR 305, DXR 315)
Automatic caterpillar track tension can be done in 2
procedures.
• Automatic caterpillar track tension can be done in
the display. Do the procedure that follows.
a) Lower the outriggers. Refer to
outriggers on page 83 .
b) Press the menu button (A) on the remote control.
B
C
A
c) Select "Track tension" in the "Functions" menu
on the display.
d) Push the right joystick forward until the tracks are
fully tensioned.
e) Release the right joystick to stop automatic
caterpillar track tension.
• Automatic caterpillar track tension can be done when
you operate the outriggers. Do the procedure that
follows.
a) Operate the outriggers up and then down. Refer
To operate the outriggers on page 83 .
to
To operate the
12345 H XX BAR
TRACK
TENSION
OUTRIGGERS DOWN! ACTIVATE AND PUSH
RIGHT JOYSTICK FORWARD
1401 - 005 - 11.01.2024