Choosing A Connection Method; Connecting Via Ethernet (Recommended) - Xerox Phaser 6125 User Manual

Choosing a Connection Method

Connect the printer via Ethernet or USB. A USB connection is a direct connection and is not
used for networking. An Ethernet connection is used for networking. Hardware and cabling
requirements vary for the different connection methods. Cabling and hardware are generally
not included with your printer and must be purchased separately. This section includes:
■

Connecting via Ethernet (Recommended)

■ Connecting via USB
Connecting via Ethernet (Recommended)
Ethernet can be used for one or more computers. It supports many printers and systems on an
Ethernet network. An Ethernet connection is recommended because it is faster than a USB
connection. It also allows you direct access to CentreWare Internet Services (IS).
CentreWare IS provides a simple interface to the embedded web server in any networked
Xerox printer that enables you to manage, configure, and monitor networked printers from
your desktop.
Network Connection
Depending on your particular setup, the following hardware and cabling is required for
Ethernet.
■ If you are connecting to one computer, an Ethernet RJ-45 crossover cable is required.
■ If you are connecting to one or more computers with an Ethernet hub, or cable or DSL
router, two or more twisted-pair (category 5/RJ-45) cables are required. (One cable for
each device.)
If you are connecting to one or more computers with a hub, connect the computer to the hub
with one cable, and then connect the printer to the hub with the second cable. Connect to any
port on the hub except the uplink port.
See also:
Configuring the Network Address
Installing the Printer Drivers
on page 3-3
on page 3-4
on page 3-5
on page 3-9
Phaser® 6125 Color Laser Printer
3-3
Choosing a Connection Method