Husqvarna TA320 Operator's Manual page 11

6. Push the trimmer line through the trimmer
head and through the opposite hole.
7. Pull the trimmer line through the trimmer
head until there is an equal length of
trimmer line on each side.
8. Hold the lower half of the trimmer head
stable with one hand. Turn the top half
of the trimmer head clockwise with your
opposite hand.
9. Continue to turn the top half of the trimmer
head until approximately 5 in. (127 mm)
of the trimmer line is extended from each
hole.
E
Note:
If the trimmer line is too long on
one side of the trimmer head, cut the
trimmer line to the correct length.
2119 - 001 - 13.07.2023
To examine and clean the trimmer head
1. Push the tabs (A) to remove the lower half
(B) of the trimmer head.
D
A
2. Remove the spool (C).
3. Remove and discard any pieces of trimmer
line and any unwanted material from the
trimmer head and spool.
4. Put the spool in the lower half.
5. Attach the top half (D). Make sure that all
parts are in the correct position and are
correctly aligned.
6. Turn the assembled trimmer head with
your hand. Make sure that the top and
bottom halves are fully closed and the tabs
are fully engaged.
7. To replace the trimmer line see
the trimmer line on page 10 .
Bevel gear
The bevel gear is filled to ¾ with grease
at the factory. Before you use the product,
make sure that the grease level has not
changed. Use Husqvarna special grease if
it is necessary to fill up. Do not replace
C
A
B
To replace
11