Xerox DocuColor 2060 Supplementary Manual page 73

Guide to Submitting Jobs from the Client
Printing using Xerox utilities and lpr utilities (DOS and UNIX)
• -C"(hcm=<action>)"
Specifies the action to take when there is a mismatch
between the highlight color you specify and the dry ink color
loaded in the printer. The default for the hcm option is
"ignore." The optional actions are as follows:
– "abort"
Requests that your job abort if the highlight color you
specify is not loaded at the printer.
– "ignore"
Requests that the available dry ink color be used to print
your job, regardless of whether you specify that color.
– "operator"
Suspends the job in an "ineligible" state while the operator
loads the color dry ink you specify.
If you specify "operator," the job prints automatically after
the operator loads the correct dry ink; however, the job
does not print until this task is completed. The job shows
in the list of documents at the printer controller, with
"Ineligible" listed as the job status.
• -C(hcr=<option>) (for models 4850/4890/92C only)
Specifies mapping a three-dimensional color application
(such as RGB) to the two-dimensional color application
provided with highlight color printing.
Since some information is lost in mapping, the color
rendering options allow you to determine what qualities are
the most important to preserve:
– pictorial
Maintains the pictorial quality as follows:
Colors with a hue matching the map color are not
changed.
Colors with a hue close to the map color are rendered
with color, but with a saturation level that decreases as
the hue shifts away from the map color.
Colors with a hue complementary to the map color are
produced in shades of gray.
3-23