Advertisement
Quick Links
Advertisement
Related Manuals for NCR 1657-K000
Summary of Contents for NCR 1657-K000
- Page 1 Kit Instructions N3000 Wall Mount Bracket 1657-K000 Issue A...
- Page 2 NCR, therefore, reserves the right to change specifications without prior notice. All features, functions, and operations described herein may not be marketed by NCR in all parts of the world. In some instances, photographs are of equipment prototypes. Therefore, before using this document, consult with your NCR representative or NCR office for information that is applicable and current.
- Page 3 Table of Contents N3000 Wall Mount Bracket Introduction Kit Components Required Tools Installation Procedures...
- Page 4 Revision Record Issue Date Remarks Jun 2018 First Issue...
-
Page 5: Kit Components
• The wall bracket is designed to be mounted using four ¼–20 toggle bolts or similar, depending on mounting substrate. • The wall bracket is designed to hold the weight of the NCR N3000 Site Controller, its external power supply, and other supporting I/O cables. No additional components or peripherals should be mounted to the wall bracket unless prior approval is given by NCR engineering. -
Page 6: Installation Procedures
N3000 Wall Mount Bracket Installation Procedures 1. Mark the screw holes. a. Using the Wall Mount Bracket as a template, hold it against the wall and mark the four holes. Take note of the "up" arrow indicating the correct orientation of the bracket. - Page 7 N3000 Wall Mount Bracket 4. If applicable, rotate the antennas so that they are parallel to the N3000. 5. Lay the N3000 face down on a flat surface. 6. Insert the four Step Pan Head Flat Screws into the hole locations marked with a W.
- Page 8 N3000 Wall Mount Bracket 7. Position the N3000 so that its ports are on top, mount the four Step Pan Head Flat Screws onto their slots on the Wall Mount Bracket, and slide the N3000 downward to lock it in place. Caution: Ensure that all four screws are fully inserted into the bracket.
- Page 9 N3000 Wall Mount Bracket 9. Insert the Power Supply into the power supply pocket on the bracket. Note: Route and tie the power cord in place as needed.