Related Manuals for NCR 7761-K462
Summary of Contents for NCR 7761-K462
- Page 1 KIT INSTRUCTIONS Arm Extension Bracket for Customer Display Integrated to P-Series Stand 7761–K462 Issue A...
- Page 2 NCR, therefore, reserves the right to change specifications without prior notice. All features, functions, and operations described herein may not be marketed by NCR in all parts of the world. In some instances, photographs are of equipment prototypes. Therefore, before using this document, consult with your NCR representative or NCR office for information that is applicable and current.
-
Page 3: Revision Record
Revision Record Issue Date Remarks Jan 2016 First Issue... - Page 4 Arm Extension Mount for Customer Display Introduction This kit provides the components to add an arm extension bracket to integrate an external customer display on the P1535/P1235 POS. The procedure below includes a procedure on attaching a sample LCD customer display to the arm extension bracket.
-
Page 5: Installation Procedure
7761-K462 (Arm Extension Mount for Customer Display) Installation Procedure 1. Remove the Cable Cover from the Extension Arm. a. Loosen the Captive Screws (2). b. Pivot the Cable Cover from the Extension Arm as shown. 2. Insert the cables into the Extension Arm. - Page 6 7761-K462 (Arm Extension Mount for Customer Display) 4. Pivot the display back. 5. Remove the Upper Stand Cover by pivoting it away from the P-Series Stand. The cover has a simple snap fit connection at the top.
- Page 7 7761-K462 (Arm Extension Mount for Customer Display) 6. Loosen the thumbscrew to open the Cable Door. 7. Route the cables up through the P-Series Stand and install the Spacer and Extension Arm Assembly onto the bottom of the stand and secure with screws (4).
- Page 8 7761-K462 (Arm Extension Mount for Customer Display) 8. Connect the cables to the corresponding connectors. Close the Cable Door and tighten the thumbscrew to secure the cables. 9. Install the Upper Stand Cover. 10. Close and secure the Cable Cover.
- Page 9 7761-K462 (Arm Extension Mount for Customer Display) 11. Install the customer display on the Arm Extension Bracket. a. Tilt the POS to a vertical position and the mounting plate of the customer display to a horizontal position. b. Insert the tabs (2) on the top edge of the mounting plate into the slots of the back of the customer display.