Xerox 4215 User Manual page 233

<
Print
Unable to
generate
prints from
the host
cut top 2"
Table D-2
Print Problem Solving
Explanation How to Correct
Prints are 5.
interface cable is
not received
connected securely
and attached to the
correct ports on both
the host computer and
the printer.
Ensure that the cable
length does not
exceed the
specification set for
your host system.
Then send job again.
If the problem is not
corrected, proceed to
the next step.
6.
in Hex Dump Mode and
resend the print job.
Refer to Chapter 2
for procedures.
6a.
prints, review
host/applications
manuals for potential
problems, then send
job again.
problem is not
corrected, call your
Xerox service
representative.
XEROX 4219/MRP Mid Range Systems Printer
XEROX 4215/MRP Mid Range Systems Printer
DIIIIIIIIHHHHHHHHIIIIIIIIIIIII
Operator Guide
Make sure the
Put the printer
If no data
If the
cut 1">
D-41