Korg Poetry Owner's Manual page 5

5. Lift up the speaker box so that the brackets (A) on
the left and right side panels pass through the dents
in the speaker box. When the brackets (A) are fully
hidden within the speaker box, push the speaker box
forward so the rear of the speaker box is nearly flush
with the edges of the side panels. Then, the speaker
box can be released.
Lift the speaker box from below the bracket.
Be careful not to pinch your fingers.
Bracket (A) Bracket (A)
Lift the dent.
Speaker cord
6. Align the bracket holes in the left and right side pan-
els with the holes in the speaker box, and then secure
them with the four screws (M4, long) so the gaps on
the left and right sides are equal.
Screws
(M4,long)
7. Attach the brackets at the holes (under the speaker
box) in the left and right side panels with the screws
(M4, short).
Threaded hole
Unthreaded hole
Screw
(M4,short)
Bracket
Lift the speaker box Lift the speaker box
from below, then from below, then
hang it onto the bracket. hang it onto the bracket.
Screws Screws
(M4,long) (M4,long)
Bracket
Screw
(M4,short)
8. Slightly bend the rear panel and insert it into the
grooves in the left and right side panels.
Be careful not to pinch your fingers.
Rear panel
9. Lift up the rear panel to align the holes in the rear
panel and the brackets installed in step 7, and then
temporarily fasten the bottom of the rear panel with
the four screws (M4, short).
Bracket
Hole in the rear panel
Rear panel
Screws (M4, short)
Screws (M4, short)
10. Fasten the rear panel and the brackets (through the
holes aligned in step 9) with two screws (M4, short).
Screw
(M4, short)
Grooves
Screw Screw
(M4, short) (M4, short)
5