Panasonic EYFLF1XA Operating Instructions Manual page 78

For example, when the torque is 30, the
snug point determining level is L1, the buzz-
er green indicator is lit and the buzz is heard,
and the undetect time is set to 1 second, the
display is as follows:
EN
"30" → "L1"→ "b1" → "10"
[EYFLF]
Check the statuses of LED light and
fault detection during running, as
well as the setting of speed control
Press button B.
The set statuses of LED light, tightening time,
and speed control setting are displayed in
sequence.
For example, when the LED light mode is set
to d1, the tightening time is set to 20, and the
speed control is set to "ON", the display is as
follows:
"d1" → "20" → P0
[EYFLF]
Confirm the set statuses of main
unit ID, tilt tightening reduction,
repeat tightening prevention, and
impact speed setting corresponding
to length of socket used
Press button D.
The set statuses of main unit ID, tilt tightening
reduction, repeat tightening prevention, and
impact speed setting corresponding to length
of socket used are displayed in sequence.
For example, when the tilt tightening reduc-
tion feature is enabled, the repeat tighten-
ing prevention is set to 0.5 seconds, and
the impact speed corresponding to length of
socket used is set to h1, the display is as fol-
lows:
"H7" → "R1" → "U2"→ "h1"
Display
H7
H8
NOTE:
When the tool is set remotely, the signal
generated from another tool nearby may
be received by accident.
To prevent such cases, set the tool in
another room if possible, or keep a dis-
tance from other tools.
Tool circuit
EYFLF1
EYFLF2
‒ 76 ‒
[EYFLF]
Confirm the set status of tightening
time reminder
Press the C button.
The set value of tightening time and the current
tightening time are displayed in sequence.
For example, "50" → "35"