Panasonic EYFLF1XA Operating Instructions Manual page 77

[EYFLF]
Setting use interval
Use interval is set to prevent the screwdriver
from continuing its operation when the tool is
automatically stopped due to the implementa-
tion of the torque correction feature. This set-
ting is valid even when the switch is off.
1. Set the tool to the configuration mode.
(See page 71.)
2. Press button D twice.
• The current set value is displayed, and
the main unit panel starts flashing.
Display: U flashing.
Battery capacity indicator: The upper
and lower bars flash.
[Fig.27]
3. Press and as required to change the
time.
Operation Display
4. Press the OK button to accept the new
setting.
• The control panel stops flashing and
lights up to display the torque clutch
settings.
NOTE:
Check the new value after you change the
settings.
Seconds
U9 3
U8 2.5
U7 2
U6 1.5
U5 1.2
U4 1
U3 0.7
U2 0.5
U1 0.3
U0 0.1
U OFF
[EYFLF]
Initializing all settings
Factory settings
• Torque clutch setting: "F" (torque control
function off)
• Interval setting: U or 0 (OFF)
• Snug point detection level → L1
• Cross thread reduction function → R0
• Rundown error detecting function → 0
• Tightening time reminder → 0
• Radio signal range limitation function →
C0
• Buzzer setting → b0
• LED light setting → d1
• Speed control setting → P0
• Undetect time setting → J0
• Impact speed setting corresponding to
the length of the socket used → h0
• One-way and two-way communication
function → q0
• This section explains how to revert all tool
settings to their default values at the time of
shipment from the factory.
• The error display will be turned off.
1. Set the tool to the setting configuration
mode. (See page 71.)
2. Press the C button.
The control panel will begin flashing.
Display: The letter "F" flashes on and off.
Battery indication lamp: The upper and
lower bars of the battery flash on and off.
[Fig.28]
3. Press the OK button to accept the select-
ed setting.
The control panel will stop flashing and
light up.
[EYFLF]
Checking Tool Settings
Confirm the set statuses of torque,
snug point determining level,
buzzer, and undetect time setting
Press button A.
The set statuses of torque, snug point deter-
mining level, buzzer, and power-off time
setting (without detection) are displayed in
sequence.
‒ 75 ‒
EN