Table of Contents
Advertisement
[hese products' balanced lather are
specially designed to complement the
'leaning action of these machines.
Jo use it regularly for trouble free
washing and superb results.
The amount of powder in grams at full load
Hardness of
Prewash
Wash when
Main
water in degrees
preceded
wash
French (°F)
L
by prewash
Soft: up to 12
20
100
Average: 12725
60
Hard: 25+37
95
—
Very hard: over 37
220 |
240
For hardness in p.pm multiply indicated
hardness value by 10.
For information regarding the degree of
hardness in your area, enquire at your
local water authority.
For reduced load or light soiling, reduce
the quantities accordingly.
Do use enough powder. To get your
clothes really clean it is essential that
enough powder is used in the machine.
The correct amount will depend on a
number of things: the hardness of water,
the size of the load, and the amount of
soiling present.
As a guide we suggest you follow the
table above and adjust the amounts in
light of your personal experience.
You may find it helps to use a measuring
cup at first.
Selection of washing programme
The washing machine carries out 10
washing programmes and 7 additional
programmes. Each programme has been
specially designed for a specific type of
fabric (e.g. cotton, synthetic fibres, wool
etc.) and incorporates the H.L.C.C. care
labelling scheme.
The appropriate programme must
therefore be chosen according to the
type of fabric to be washed.
Starting
After loading the clothes, the washing
powder and the fabric conditioners into
the respective compartments, make sure
— before you start the machine — that:
the plug is in the wall socket
the water tap is turned on (fully open)
the drain hose is correctly placed
the lid is correctly closed.
You may now select the required wash
eycle by turning the programme control
knob clockwise after making sure that it
is pressed in.
To enable the spin only cycle to operate
correctly it is essential that care is taken
to ensure correct indexing. Failure to do
this could result in damage to the
appliance. Having selected programme J
or U, ensure that the reference points on
the timer knob are exactly in line with
the reference points on the fascia panel.
Press in the required pushbutton, if any.
At this point, to start the washing
machine simply pull the programme
control knob (and the pilot lamp lights
up). Once it is started, the machine will
automatically carry out all phases of the
selected programme.
Stopping
When the programme is completed the
machine stops automatically.
You should now press in the programme
control knob (pilot lamp goes out), and
wait for about 1-2 minutes after the wash
cycle is completed before you open the
lid, so as to allow the door safety device
(interlock) to release it. If need be, you
may stop the machine at any given
moment during the cycle by pushing in
the programme control knob. If the
machine stops during a spinning phase,
it is absolutely necessary — to restart it —
that you reset the machine on the
programme immediately preceding the
stopping point. When the wash cycle is
completed, it is advisable to unplug the
machine from the wall socket and to
turn off the water tap.
Advertisement
Table of Contents
