Table of Contents
Advertisement
Washing powder should only be placed
in the dispenser immediately prior to the
start of a programme.
Do not leave washing powder in the
dispenser for any length of time as it
may form lumps which can be difficult to
dissolve.
It is advisable to inspect the filters in
the water inlet hoses periodically and
clean if necessary.
14
Servicing
Should servicing be required for this
appliance contact your local Service
Agent but before requesting service the
following simple checks may save you
inconvenience and expenses:
@ The machine won't start
Check that the plug is firmly in the wall
socket and that there is an electricity
supply by plugging in another appliance.
Check that the lid of the machine is
firmly closed.
Check that the required programme is
correctly selected.
Check that the programme selector knob
is actually pulled out;
Make sure the fuses of your electrical
installation have not blown.
è The machine won't fill
Check that:
the water tap is actually turned on and
that there is sufficient pressure.
The lid is firmly closed.
è The machine fills, but the water
empties from the drain hose
Check that:
the end of the drain hose is not placed
too low from floor level.
è The machine won't drain or spin
Check that:
the drain hose is not sharply bent
(kinked) or placed in such a way as to
obstruct a normal water flow.
The drain pump filter is not clogged.
è The machine vibrates or is too noisy
Check that:
The machine is correctly levelled and
steadied as described in the relevant
paragraph.
The washer is not too close to a wall or
to the furniture.
Advertisement
Table of Contents
