Kawai Heritage 200 Classic Instruction Manual page 10

(Step 3.)
( Step 4 )
Hold down the SPLIT button and press a TONE SELECTOR to change the
LOWER tone. The selected tone becomes the LOWER tone. The LED for the
UPPER keyboard sound glows continuously. The LED for the LOWER keyboard
flashes. For the bass sounds, the three buttons on the right end of the TONE
SELECTOR section will select the preset bass sounds: WOOD BASS, ELECTRIC
BASS, and SLAP BASS. Pressing one of these buttons, while the SPLIT button is
lit, will select the desired bass sound. Pressing one of these buttons, while holding
down the SPLIT button, will select the preset sound: HARPSICHORD, VIBRA-
PHONE, or STRINGS.
Ta |
SPLIT PIANO 1 PIANO 2 E.PIANO JAZZ CHURCH HARPS!- VIBRA- STRINGS
ORGAN ORGAN CHDRD PHONE
track 1
wm _ile
( Ww ELECTRIC SLAP
bey —
LOWER BASS
Adjust the relative loudness of the two tones colors with the DUAL/SPLIT BAL-
ANCE control
Moderato
Andante Allegro
Ba ie as
SLOW 2) FAST
left TE right
dual/split balance
To cancel the SPLIT MODE push the SPLIT button again. The LED above it will
turn off and the keyboard will return to normal play.
*When the SPLIT function is first activated, the keyboard is split at the
point
marked on the front panel, and the LOWER keyboard assumes the WOOD
BASS tone.
*The LOWER tone specification remains in effect until the power is turned
off or the tone is changed.
*Switching from DUAL to SPLIT operation makes the UPPER keyboard
assume the right tone and the LOWER assumes the WOOD BASS or the
tone selected for the LOWER tone.
*You must turn the SPLIT operation off before you can return to DUAL
operation.
*To change the SPLIT point, see page 23 "Changing the Split Point".