Advertisement
i Cartridge
I Input impedance
The input impedance of the 'PHONO
1" and '"'PHONO 2"
terminals can be changed to 25ka, 50ka and 100ka by using
the input impedance
selector.
After first reading the operating instructions of the cartridge
to be used, set the impedance to the value which is closest
to the specified impedance.
if the
input impedance
is higher than the specified
load
impedance
of the cartridge, the treble range will become
higher, and, if lower, the treble range will become lower.
Thus you can enjoy various tone qualities with one cartridge.
Most cartridges can be used at an input impedance of 50ka.
Mi Disc performance
41. Set the input selector to the position corresponding
to
the record player to be heard ('PHONO 1" or 'PHONO
2").
2. Set the tape-monitor selector to the "SOURCE" position.
. Release the mode pushbutton to the ''STEREO" position.
. Switch
the turntable
on
and select the proper
playing
speed.
5, Place
the tone
arm
on
the
record
and
increase
the
volume gradually to the most comfortable listening level.
6. Make other adjustments in accordance with your taste
and the acoustics of the room.
Oo
These istmingle are for connection with the output terminals
of a tape deck or 8-track stereo, a semiconductor cartridge
with head amplifier, etc.
Mi Reproduction
1. Set the input selector to the ''AUX"' position.
2. Set the tape-monitor selector to the ''SOURCE"' position.
3. Release the mode pushbutton to the '""STEREO" position.
4. Sound will be heard by operating the sound source and
turning the volume control clockwise.
You can connect 2 separate tape decks directly to this unit.
The electronic characteristics of both tape deck terminals
(1 and 2) are identical.
Not only can this unit be used for
recording
to two tape decks
at the same
time,
but tape
"dubbing'' (recording from one tape deck to another) is also
possible.
'
—10~
Mi Connections
Connect the playback terminals of this unit with the output
terminals ("LINE OUT') of the tape deck.
Connect the recording output terminals of this unit with the
input terminals ('LINE IN'') of the tape deck.
PLAYBACK
ri a
LINE IN
REC OUT
Tape deck 1
PLAYBACK
Tape deck 2 LINE OUT
I Recording/playback terminal
Do not connect a tape deck to the DIN terminal and to the
pin-type terminals for tape deck 1 at the same
time.
Connect to only one or the other.
cable
VO
| oom pe
2
PLAYBACK
rec /PLay |edit
mee
Tape
ape deck E B
Do not connect to the pin terminals
and the DIN
REC
OUT
Tape
rape deck A
terminal
at the same time.
M@ Playback from a tape deck
1. Select the tape deck with the tape-monitor selector.
(The input selector has no effect in any position.)
For playback
from
tape
deck
1, set
the
tape-monitor
selector to the "TAPE 1' position.
For playback from tape deck 2, set the tape-monitor
selector to the 'TAPE 2" position.
2. Release the mode pushbutton to the "STEREO" position.
3. After preparing the tape deck for playback, increase the
volume gradually to the most comfortable listening level.
4. Make
other adjustments
in accordance
with your taste
and the acoustics of the room:
W@ Recording with a tape deck
When the tape-monitor selector is in the "SOURCE," "TAPE
1" or "TAPE 2" position, the signal which has been select-
ed with the input selector
is constantly
supplied,
as a
signal for recording, from the tape deck 1 and tape deck 2
recording output terminals.
In this instance, all operating controls, such as the volume
Advertisement
