Firmware Update; Factory Reset - Sony MDR-7506 Service Manual

Hide thumbs Also See for MDR-7506:

Table of Contents

Mustang Micro can be used as an input device for digital recording software by using a USB

cable to connect the USB-C jack (H) on the bottom of the unit to the USB port on the user's

Mac or PC.

Note that Mustang Micro can only be used as a source for USB audio (which cannot be routed

back to Mustang Micro for monitoring).

No external driver is needed to connect to an Apple computer. For assistance with configuring and using USB record-

ing, visit the "Connected Amps" section at https://support.fender.com.

Updating firmware on Mustang Micro requires use of the Fender Mustang Micro Updater

application, which can be downloaded at www.fender.com/mmfirmware when updates are

made available. The installer will guide the update process using the three steps below:

1. With Mustang Micro off, connect a USB cable to its USB-C jack and connect the other end

to a Mac or PC.

2. Press and hold the AMP "-" button (C).

3. Turn Mustang Micro on while continuing to hold the AMP "-" button for three seconds.

Successful initiation of firmware update mode is then indicated by a solid white POWER SWITCH LED (G) for 10 sec-

onds; the white LED will then begin flashing to indicate an update in process.

When a firmware update is complete, the POWER SWITCH LED will illuminate solid green to indicate a successful up-

date; the LED will illuminate solid red to indicate a failed update. Mustang Micro is automatically powered up during

the firmware update process; when an update is completed successfully, disconnect the USB cable from Mustang

Micro and restart the unit.

FIRMWARE UPDATE

INITIATED (SOLID)

IN PROCESS (FLASHING)

A Mustang Micro factory reset can be performed that resets all buttons (AMP, EQ, EFFECTS, MODIFY) to their original

factory values and clears the Bluetooth paired device list.

Initiate factory reset mode by turning Mustang Micro on while simultaneously holding the EQ "+" (D) and EFFECTS "-"

(E) buttons for three seconds. The LEDs above the EQ and EFFECTS buttons will illuminate white after factory reset (as

will the LEDs above the AMP and MODIFY buttons not shown below).

RECORDING

FIRMWARE UPDATE

SUCCESSFUL (SOLID)

FIRMWARE UPDATE

FAILED (SOLID)

Table of Contents