Table of Contents
Advertisement
For each additional system:
1.
Manually set the group number to match the first receiver (see Manual Group and Channel Selection).
2.
Perform a channel scan by pressing the scan button.
3.
Sync the transmitter to the receiver.
Important: After syncing each transmitter, leave it on so that scans from the other receivers do not select that channel. Be sure only one transmitter IR port is
exposed when synchronizing each system.
Manual Group and Channel Selection (receiver only)
Important: Most single-system applications do not require manual group or channel settings--use an automatic frequency scan instead. However, it may be
useful for some applications, such as to tune to and record audio directly from a microphone in a compatible wireless installation.
To set the group:
1.
Press the scan and sync buttons simultaneously. The GROUP display flashes.
2.
Press the sync button to change the group number.
3.
Press scan to accept the selected group.
4.
Press scan again to save and exit.
5.
If desired, perform a channel scan to select an open channel in that group.
To set the channel:
1.
Press the scan and sync buttons simultaneously. The GROUP display flashes.
2.
Press scan to move to the channel setting. The CHANNEL number flashes.
3.
Press the sync button to advance to the desired channel number.
4.
Press scan to save and exit.
Note: Remember to sync the transmitter to the receiver.
Automatic Frequency Scan
If you experience RF interference, switch to a new channel using the channel or group scan.
Channel scan: Press the scan button on the receiver. Switches to new channel in the same group.
Group scan: Press and hold the scan button for 3 seconds. Finds a new group and selects an open channel in that group. (Do
not use in multiple system setups unless all systems are moved to the same group.)
Locking and Unlocking the Transmitter
Locking the transmitter prevents accidental changes during performances.
To lock the controls: With the transmitter off, hold the power button down until the green LED flashes (~5 seconds)
To unlock the controls: With the transmitter on, hold the power button down until the green LED flashes (~5 seconds)
Shure Incorporated
16/26
Advertisement
Table of Contents
