Adjusting Gain; Fp1 And Fp3 - Shure FP Series Manual

Rapid flashing red after synchro­
nization
② Power Button
Press and hold to power on or off.
③ Infrared (IR) Port
Receives infrared beam to synchronize frequencies. When using multiple systems, only one transmitter IR port should be
exposed at a time.
④ 4-Pin Microphone Input Jack
Use with with a TA4F connector for a lavalier or headset microphone.
⑤ Audio Input Gain
Adjusts audio level.
⑥ XLR Connection (FP3 only)
Plug into an XLR microphone or the output of an audio device.
⑦ Audio Input Level Indicator (FP3 only)
Red
Yellow
Green

Adjusting Gain

FP1 and FP3

Perform a sound check. Use the audio gain control located on the side (FP1) or front (FP3) of the unit to adjust the gain up (+)
or down (−) until desired level is reached.
FP3 only: Adjust so the audio input level indicator flickers yellow at peak sound levels.
Transmitter and receive incompatible; contact your Shure reseller
Signal clip
Nominal peak
Audio present
Shure Incorporated
13/26