Scag Power Equipment V-RIDE II SVRII-32A-23BV Operator's Manual page 35

Section 6
B. Turn the adjustment bolts on the front and rear either
clockwise to raise or counterclockwise to lower the
cutter deck until the measurements are equal. Tighten
the elastic stop nuts.
LOOSEN HERE
ADJUST HERE
Figure 6-7. Right Side Cutter Deck Adjustment
This adjustment will set the cutter deck with no pitch. If
a pitch in the cutter deck is desired, Cutter Deck Pitch
Adjustment on Page 28.
CUSTOM-CUT BAFFLE ADJUSTMENT
The Custom-Cut Baffle is designed to deliver optimum
airflow and superior cutting performance in any type of
grass. The Custom-Cut Baffle can be raised or lowered
to precisely tailor the deck's performance for the type of
grass being cut. The baffle can be set in seven (7) different
positions for optimum performance.
A. 3-1/2" or 3-3/4" Position - See Figure 6-8. For very
tall, wiry or tough-to-cut grass.
B. 4" (factory setting), 4-1/4" or 4-1/2" Position - See
Figure 6-8. For general purpose cutting. This gives the
best mix of cutting performance in all types of grass.
C. 4-3/4" or 5-1/4" Position - See Figure 6-8. Placing
the baffle in either the 4-3/4" or 5-1/4" setting will
enhance fall cutting (leaf pickup) and reduce cutter
deck "blowout".
ADJUST HERE
To adjust the Custom-Cut Baffle height:
1. Park the machine on a flat surface, apply the parking
brake, shut off the engine and remove the key.
2. Place the cutter deck in the transport position.
3. Remove the hardware securing the Custom-Cut
Baffle to the cutter deck.
Hardware location used in the illustrations are for
reference only. Location of hardware may vary
depending on cutter deck size.
4. Move the Custom-Cut Baffle to desired position. See
Figures 6-8.
5. Reinstall the mounting hardware. Torque hardware
to 39 ft-lbs.
31
- NOTE -
R