The Earch Rocedure; Ontrolling; Code - X10 UR73A Owner's Manual

I I I I I C C C C C
DENTIFYING DENTIFYING ODES ODES FOUND FOUND
DENTIFYING DENTIFYING DENTIFYING ODES ODES ODES FOUND FOUND FOUND USING
S S S S S P P P P P
THE THE THE THE THE EARCH EARCH EARCH EARCH EARCH ROCEDURE ROCEDURE ROCEDURE ROCEDURE ROCEDURE
1 . 1 . 1 . 1 . 1 . Press and hold the
SETUP until the LED
indicator lights
steadily. Release
Setup button.
2 . 2 . 2 . 2 . 2 . Press the mode
button that matches
the equipment you
want to identify.
The LED blinks
once.
3 . 3 . 3 . 3 . 3 . Press and release
SETUP. The LED
blinks once.
4 . 4 . 4 . 4 . 4 . To find the first
digit, press each
number button from
0 to 9 until the LED
blinks. The number
you pressed is the
first digit of the

code.

5 . 5 . Press each number 5 . 5 .
5 .
button from 0 to 9
again as above to
find the second
digit.
6 . 6 . 6 . 6 . 6 . Press each number
button in turn to
find the third digit.
When the third
digit has been
found, the LED goes
out.
1 4 1 4
1 4 1 4 1 4
C C C C C

ONTROLLING

ONTROLLING ONTROLLING ONTROLLING ONTROLLING
X10 M X10 M
X10 M X10 M X10 M
USING USING
USING USING
If you have purchased and installed a
Transceiver Module, you can control it
and other X10 modules as follows:
1 . 1 . 1 . 1 . 1 . Press and release
the X10 button.
2 . 2 . 2 . 2 . 2 . Use the number
buttons to enter the
Unit Code number
of the chosen
module. (You do
not need to enter
'0' first for a single
digit number.)
3 . 3 . 3 . 3 . 3 . Press the appro-
priate button for
the function you
require (see
below).
X10 FUNCTIONS:
On:
Off:
Bright:
Dim:
All Lamps On:
All Modules Off:
Note: You cannot dim or brighten an
Appliance Module. If the module was off
and you press Bright or Dim (VOLUME+
or VOLUME-) this will simply turn the
module on.
ODULES ODULES ODULES ODULES ODULES
CHANNEL +
CHANNEL –
VOLUME +
VOLUME –
POWER
MUTE
1 5 1 5
1 5 1 5 1 5