Shutting Off The Machine; Recycling The Clippings; Bagging The Clippings - Toro eTimeMaster eTM76 Operator's Manual

Shutting Off the Machine

1. Release the blade-control bar (A of
2. Remove the electric-start button from the
electric-start switch (B of
3. Remove the battery pack; refer to
Battery Pack from the Machine (page
Note:
Whenever you are not using the machine,
remove the battery pack.
Figure 16

Bagging the Clippings

Use the grass bag when you want to collect grass and leaf clippings from the lawn.
If the side-discharge chute is on the mower, remove it before bagging the clippings; refer to
Side-Discharge Chute (page
Installing the Grass Bag
1. Raise and hold up the rear deflector (A of
2. Remove the rear-discharge plug by pulling down on the latch with your thumb and pulling the plug out
from the machine (B of
3. Install the bag rod into the notches at the base of the handle and rock the bag back and forth to ensure
that the rod is seated at the bottom of both notches (C of
4. Lower the rear deflector until it rests on the grass bag.
Figure 16).
Figure 16).
Removing the
17).
g335480
15).
Figure
Figure 18).

Recycling the Clippings

This machine comes from the factory ready to recycle
grass and leaf clippings back into the lawn. To prepare
the machine to recycle, do the following:
•
If the side-discharge chute is on the machine,
remove it and lower the side-discharge deflector;
refer to Removing the Side-Discharge Chute
(page 15).
•
If the grass bag is on the machine, remove it; refer
to Removing the Grass Bag (page
•
If the rear-discharge plug is not installed, grip it by
the handle, raise the rear deflector, and insert it
into the rear-discharge chute until the latch locks
into place; refer to
18).
Figure 18).
14
15).
Figure 17.
Figure 17
Removing the
g426214