Eizo CuratOR EX5841 Installation Manual page 17

Function Values
Service Backlight Sensor Test
Reset to Factory Defaults
Presets Open Factory Preset
Open User Preset
Save as User Preset
Edit User Preset Name
Ethernet
Ethernet Settings Ethernet <on/off>
DHCP <on/off>
Host <Name>
IP <IP Address>
Sub <IP Address>
Gate <IP Address>
Default:
Ethernet <off>
DHCP <on>
Host <EIZO>
IP <000.000.000.000 >
Sub <255.255.255.000>
Gate <192.168.000.001>
Ethernet Status For display only
CuratOR EX5841
Installation Manual, 06/2021
Description
Backlight Sensor Test
When you select this function, a series of bright-
ness settings is checked using the internal sen-
sor.
Reset to Factory Defaults
Selecting this function opens a dialog box where
you can reset the device to the factory settings.
Open Factory Preset
Select one of the saved factory presets for opera-
tion.
Open User Preset
Select one of the user presets for operation.
Save as User Preset
The following settings are saved in the user pre-
set:
• Name User Preset
• Source, Color Space, and Input Range for
each video input
• LUT for each window
• Color Gamut and Zoom
• OSD position (optional)
Edit User Preset Name
Change the name of a user preset.
Ethernet settings for monitor system mode
With "Ethernet" you switch remote access on or
off.
You establish the access data for remote access
with "DHCP", "Host", and the addresses for IP,
Sub, and Gate.
Information regarding Ethernet connection
and MAX address
• Bitrate [Mbit] 10 / 100
• Duplex Full / Half
• MAC-Address: 00:90:93:2D:xx:xx
Note: The MAC address of the monitor is estab-
lished during calibration ex-factory. It is in the
range 00:90:93:2D:xx:xx, where xx = 00:00 –
FF:FF.
Commissioning
2.9 Other Options menu
17