Eizo CuratOR EX5841 Installation Manual page 10

Commissioning
2.6 Display menu
Function
Backlight (BL)
Test Pattern
Source Settings
Color Space
Input Range
10
Values
LUT BL Active
BL Regulation
BL Brightness 0...1023
None
MEASURE
GRAYBARS
CROSS
PIXEL_ON_OFF_HORI
GRAY RAMP
TG18-OIQ
Default: None
SDI
HDMI
DP
DVI
BT.709
BT.601
BT.2020
Default: depends on the
selected preset
0-255
16-235
16-255
Default: depends on the
selected preset
Description
Backlight command
If the setting is marked, the brightness is deter-
mined by the active LUT. This ensures that the
maximum brightness fits with the gamma curve.
Reserved for future use.
Changing the brightness of the backlight
If you select this setting, the "LUT BL Active"
setting is disabled.
CAUTION: If you adjust brightness, the gray
scale values no longer correspond to the set
gamma curve (LUT). As a result, the calibrated
values cannot be guaranteed and there could be
a loss of information in the displayed images.
Select and display test patterns
The monitor contains an internal test pattern
generator that can create various test patterns to
enable visual checks of the device without soft-
ware.
CAUTION: Only use the test patterns during
service activities. The PiP functions are deacti-
vated when a test pattern is displayed.
Note: After selecting a test pattern, select
"None" in order to display the video signals of
the connected system again.
Select the video source in order to set the "Color
Space" and "Input Range".
Establish the conversion standards for the color
format of the selected video source.
Note:
• Color Space settings only impact a YCbCr
signal.
• Not available for DVI.
Establish the dynamic range of the selected
video source.
Note: Not available for DVI.
Installation Manual, 06/2021
CuratOR EX5841