Troubleshooting; Error And Warning Messages - CAME BXV06AGL Installation Manual

ERROR AND WARNING MESSAGES

E1 The travel calibration was interrupted to activate the STOP button.
E2 Adjustment error
E3 Motor control error
E4
Service test failure error
E7 Operating time error
E9 Obstacle detected during closing
E10 Obstacle detected during opening
E11 The maximum number of obstacles detected consecutively has been exceeded
E13 The limit switches are both open
E14 Serial communication error
E15 Incompatible transmitter error
E17 Wireless system communication error
E18 Wireless system not configured error
C0 Wire contact 1-2 (NC) is open.
C1, C2, C3, C4 The photocell wire contact (NC) is open.
C7, C8 The sensitive edge wire contact (NC) is open.
P0 The wireless radio contact 1-2 (NC) is open.
P1, P2, P3, P4 The photocell wireless radio contact (NC) is open.
--- Control board has no travel auto-learning

Troubleshooting

Error shown Action
Connect cables MN and +E-
Check the gate is not blocked
The encoder module is not installed
Measure the voltage between M and N
E3
Thermal protection is activated
Check the position of the limit-switches and speed (gate open and gate closing)
Check the control board is intact
Check the motor is intact