Table of Contents
Advertisement
• Each press of the button increases the delay
time by 1 hour, for up to 19 hours.
• Once the desired delay time is set, press the
Start/Pause button to start the delay time.
NOTE
• If the Start/Pause button is not pressed to begin
the delay time, the washer automatically turns
off after a certain time and all cycle settings are
lost.
Faucet
Press the Faucet button to turn the cold water on
in the tub, so you can spot clean items before
putting them in the tub to wash.
• To stop the water, close the lid or press the
Faucet button again.
• After the Faucet option is turned off, the water is
automatically drained.
NOTE
• The function ends when the water reaches the
maximum fill level or after 5 minutes.
• If the door is not opened for 4 minutes after
starting, the Faucet function will stop.
• After using the Faucet function, press the Power
button if you want to use the water in the tub.
• When using Faucet function, it is a possible that
the cycle time displayed will increase compared
to the actual load due to the increased water
level.
• If the hot and cold water hoses are connected in
reverse, hot water comes out. Hot water is not
suitable for spot cleaning and can cause serious
injury. Make sure the cold water inlet hose is
attached to the cold water inlet.
Deep Fill
Use this option to add water to the wash cycle for
better wash performance with large or bulky
items.
NOTE
• If the washer reaches its maximum water level,
this button will have no effect.
• To add more water while a cycle is running,
pause the cycle and select this option.
• When you select the Normal cycle and the Deep
Fill option, the cycle is changed to the Deep
Wash cycle before starting.
More Options
1
Press the Settings button.
2
Turn the knob to select the desired option and
press the
8
(OK) button.
3
Turn the knob to select On or Off and press
the
(OK) button to save the option.
8
4
To return to the previous screen, press the
Settings button again or press the
(Previous) button.
NOTE
• If no action is taken for several minutes after
pressing the Settings button, the display reverts
to the previous screen.
TM
TurboWash
Adding this option reduces the cycle time while still
providing similar wash performance to the same
cycle without TurboWash
ColdWash
Use this option to save energy by using cooler
water while increasing the wash and rinse times to
maintain wash performance.
• Wash time will increase up to several minutes
with this option.
• For best wash results, only wash small loads (less
than 8 lb) with this option.
Soak
This option provides a 30-minute presoak prior to
the start of the selected cycle. Use this option to
presoak garments to help remove difficult spots or
OPERATION
33
N
TM
.
Advertisement
Table of Contents
