Related Manuals for NARVI Oy Finland 30
Summary of Contents for NARVI Oy Finland 30
- Page 1 Made by NARVI Oy Finland Narvi 30, Narvi 50 Installation, user and maintenance instructions...
- Page 2 Yrittäjäntie 14, FI-27230 Lappi • tel. +358 0207 416 740 • fax +358 0207 416 743 • www.narvi.fi/en...
-
Page 3: Table Of Contents
Content Technical data Before you install the sauna heater Steam room Substrate Safety clearances Smoke ue Ventilation Installation and preheating of the sauna heater Preheating Connection with the smoke ue Changing of the opening direction of the rebox door Sauna heater stones Installation of a tunnel sauna heater Using the sauna heater Firewood... -
Page 4: Technical Data
Narvi 30, Narvi 50 Introduction Thank you for having chosen a Narvi sauna heater. To make the most of your sauna heater please read the manual carefully before you start installing and using it and keep the manual for future reference. This user manual contains the technical data of your sauna heater and installation, use and maintenance instructions. -
Page 5: Before You Install The Sauna Heater
An air gap stalled on a wooden oor. The weight of the sauna heater of at least 30 mm must be left between the surface to be is shown in clause 1.1. -
Page 6: Ventilation
Please observe that the safety clearance of an uninsu- lated smoke ue from structures made of combustible materials is 1000 mm or any other distance stipulated in the manufacturer’s instructions. 2.3.2 Non-combustible structure If the wall is masonry or other structure classi ed as non- combustible, it is suf cient to have a 50 mm air gap be- tween the upright surfaces and the wall. -
Page 7: Installation And Preheating Of The Sauna Heater
3. Installation and 3.3 Changing of the opening direction of the firebox door preheating of the sauna heater 3.1 Preheating Before use and arranging the stones, the sauna heater must be heated to remove the protective agents. Any pro- tective lms and stickers must have been removed before. Preheating shall be carried out on a non-combustible surface and outside, since paint emits harmful solvents and smoke during heating. -
Page 8: Installation Of A Tunnel Sauna Heater
For additional information see clause 2.3. Measures of a tunnel opening: Y mm X mm Narvi 30 Narvi 50 Figure 9. Figure 9. Installation of a tunnel sauna heater. For sealing brickwork and tunnel part we recommend the use of a mineral wool slab, which provides moving space required for thermal expansion. -
Page 9: Using The Sauna Heater
The sauna heater must not be Heating of the sauna: covered with anything. Narvi 30 To start heating pile rewood over a suf ciently wide area and ignite it from above. For ignition you may use birch 1. -
Page 10: Steam Water
Do not forget that the sauna heater and its part be- steam water. Do not throw water on the stones, if you your- come very hot during heating. If you need to touch the self or somebody else is right next to the sauna heater. Hot parts of the sauna heater, always use protective gloves. -
Page 11: Soot Fire
5. Soot fire the warranty or other defects that appear later than two (2) years after the delivery of the goods to the client. The supplier may decide to either repair the defective goods IN CASE OF SOOT FIRE (ALSO IF IT or replace the defective goods at its own direction. - Page 12 Pass 387 C Flue gas temperature Pass Mechanical resistance Thermal output and Energy efficiency, as: Pass (0,30 %) - carbon monoxide emission at 13 % O - total efficiency Pass (70 %) - flue draught 17 Pa - thermal output 24 kW (i.e.