Samsung WD1 T Series User Manual page 180

Installation
STEP 4 Connect the water hose
The provided water hose may differ depending on the model. Please follow the instruction according to the
provided water hose.
Connecting to a threaded water tap
WARNING
If there is a water leak, stop operating the washing machine and disconnect it from the electrical supply.
Then, contact a local Samsung service centre in case of a leak from the water hose, or contact a plumbing
technician in case of a leak from the water tap. Otherwise, this may cause electric shock.
CAUTION
Do not stretch the water hose by force. If the hose is too short, replace the hose with a longer, high-pressure
hose.
22 English
U-PJT_COMBO-AD_SimpleUX_WEB_SSEC-02__EU_English.indd 22
1. Connect the water hose to the water tap, and then
turn it to the right to tighten.
CAUTION
Before connecting the water hose, make sure there is
a rubber washer in the hose connector. Do not use the
hose if the washer is damaged or missing.
2. Connect the other end of the water hose to the
inlet valve on the back of the washing machine,
and then turn it to the right to tighten.
3. Slowly open the water tap and check if there are
any leaks around the connection areas. If there are
water leaks, repeat step 1 and 2.
2022/4/16 11:05:18