Wolf IM15/S Installation Instructions Manual page 7

I N S TA L L AT I O N I N S T R U C T I O N S
I N S TA L L AT I O N O P T I O N S
M U LT I P L E C O O K T O P I N S TA L L AT I O N
If the multi-function cooktop is to be used with
any combination of additional cooktop units or
modules with a filler strip, the cut-out width is
calculated by adding the corresponding units'
1
cut-out dimensions plus 1
additional unit. Refer to the illustration below.
IMPORTANT NOTE: When multiple cooktops
and/or modules are installed side by side, each
unit must have its own separate recommended
electrical circuit. When multiple gas cooktops
and/or modules are installed next to one
another, they can receive their gas supply from
a common line. However, each unit MUST
have its own gas pressure regulator installed
between the mainline and the cooktop or
module.
When two or more modules are installed
together, an integrated module filler strip
(IFILLER/S) is required. If a downdraft ventila-
tion system is also installed, an integrated
module support for downdraft ventilation
(ISUPPORT) is also required. Contact your Wolf
dealer for information on these accessory
components.
3
59 / "
4 (1518) FOUR MODULES WIDTH OR
1
59 / "
2 (1511) 30" COOKTOP AND TWO MODULES OR
1
50 / "
4 (1276) 36" COOKTOP AND ONE MODULE
1
44 / "
2 (1130) THREE MODULES WIDTH OR
1
44 / "
4 (1124) 30" COOKTOP AND ONE MODULE
1
29 / "
4 (743)
TWO MODULES WIDTH
1
14"
19
(356) (489)
CUT-OUT CUT-OUT
1
2 / "
2 min
WIDTH DEPTH
(64)
FRONT OF COUNTERTOP
Countertop cut-out dimensions for installation of multiple cooktops
and/or modules
IMPORTANT NOTE: Refer to specific
installation requirements and limitations for
each integrated module. Review specific
installation instructions for product to product
capabilities. Additional information is provided
on our website, wolfappliance.com
/ " (32) for each
4
/ "
4
O P T I O N A L
I N S TA L L AT I O N S
Dimensions will
vary according to
the specific
installation.
7