Wolf IM15/S Installation Instructions Manual page 12

W O L F
C O O K T O P
Insert the cooktop into the countertop cut-out
opening. Center the cooktop in the opening
and make sure that the front edge of cooktop
is parallel to the front edge of the countertop.
Check that all required clearances are met. Use
a pencil to outline the rear edge of the cooktop
on the countertop. Remove the cooktop from
the countertop opening.
IMPORTANT NOTE: When repositioning the
cooktop in the countertop cut-out opening, lift
the entire cooktop up from the opening to
prevent scratching the countertop.
Remove the foam strip from the hardware
package. Apply the foam strip around the
bottom of the burner box flush with the edge
as shown in the illustration below.
Reinsert the cooktop into the countertop
opening. Check that the cooktop is parallel to
the front edge of the countertop. Lift the entire
cooktop to make adjustments and align the
rear edge with the pencil line.
Attach the brackets to the burner box by insert-
ing the clips into the rectangular punchouts on
the left and right side of the burner box. Insert
the 3
brackets. Use a screwdriver to tighten the
clamping screws against the underside of the
countertop. Refer to the illustration below. Do
not overtighten screws.
Cooktop
Burner Box
Foam strip application
12
M U LT I - F U N C T I O N C O O K TO P
I N S TA L L AT I O N
1
/ " (89) clamping screws into the
2
Burner Box
Foam
Strip
Bracket
Bracket installation
G A S P R E S S U R E R E G U L A T O R
Install the gas pressure regulator with the
arrow on the regulator pointing up toward the
unit and in a position where you can reach the
access cap. Refer to the illustration below.
A natural gas and LP compatible pipe-joint
compound should be used to ensure a gas-
tight seal.
IMPORTANT NOTE: All connections must be
wrench-tightened. Do not make connections to
the gas pressure regulator too tight; this may
crack the regulator and cause a gas leak. Do
not allow the regulator to turn on the pipe
when tightening fittings.
G A S S U P P LY L I N E C O N N E C T I O N
Assemble the flexible metal connector from
the gas supply pipe to the gas pressure regula-
tor. You will need to determine the fittings
required, depending on the size of your gas
supply line, flexible metal connector and shut-
off valve. Refer to the illustration on page 13.
Use a pipe-joint compound made for use with
natural and LP gas. If a flexible metal connec-
tor is used, be sure the tubing is not kinked.
Open the shut-off valve in the gas supply line.
Wait a few minutes for the gas to move
through the line. Refer to the illustration on
page 9.
Countertop
1
3 / "
2 (89)
Clip
Clamping
Screw
Pressure Rear of
Regulator Cooktop
Access Gas Flow –
Cap Arrow
Points Up
Gas pressure regulator