Wolf IM15/S Installation Instructions Manual page 6

W O L F
S I T E
L O C AT I O N R E Q U I R E M E N T S
The following minimum dimensions must be
maintained when installing the Wolf gas
multi-function cooktop, Refer to the Installation
Specifications illustration on page 5.
Minimum horizontal clearance from the
sides and back of the cooktop cut-out to
adjacent vertical combustible construction,
extending a minimum of 18" (457) above
the countertop, 7" (178) from side edges
of cut-out and 2
cut-out.
Minimum 24" (610) clearance between the
countertop and the bottom of a wood or
metal cabinet which is protected by not less
than
covered with not less than No. 28 MSG
sheet steel, .015" (.4) stainless steel, or
.024" (.6) aluminum or .02" (.5) copper.
Minimum 30" (762) clearance between the
countertop and the bottom of an unpro-
tected wood or metal cabinet.
IMPORTANT NOTE: When installing a ventila-
tion hood, refer to the specific requirements
of the hood for the minimum dimension to
countertop.
Failure to locate the cooktop without the
proper clearances will result in a fire
hazard.
6
M U LT I - F U N C T I O N C O O K TO P
P R E P A R A T I O N
1
/ " (64) from rear edge of
2
1
/ " (6) flame retardant millboard
4
C O U N T E R T O P C U T- O U T D I M E N S I O N S
IMPORTANT NOTE: Countertop opening
dimensions shown in the Installation Specifica-
tions illustration on page 5 must be used.
The dimensions shown provide for required
clearances.
The multi-function cooktop is designed to fit a
standard 24" (610) deep base cabinet with a
25" (635) deep countertop. Before making the
countertop cut-out, verify that the cooktop will
clear the side walls of the base cabinet below.
1
There should be at least 5
between the countertop and any combustible
surface directly below the unit.
If the cabinet has a drawer, a 5
ance from the countertop to the top of the
drawer (or other obstruction) in the base
cabinet is required. A 15" (381) or less drawer
depth may be needed to avoid interfering with
the gas pressure regulator.
IMPORTANT NOTE: When multiple cooktops
and/or modules are installed side by side,
refer to the countertop cut-out dimensions on
page 7.
Dimensions in parentheses are in
millimeters unless otherwise specified.
/ " (140) clearance
2
1
/ " (140) clear-
2