Panasonic Palmcorder PalmSight PV-L779 Operating Instructions Manual page 11

Supplying Power
Charge the Battery Pack
Charge Battery Pack fully before use.
1 Piug in AC Adaptor.
Lamp 2
Insert Battery. .
© Align right side of Battery with line
on AC Adaptor.
(3 Press Battery down and slide in
direction of arrow.
CHARGE Lamp lights and then goes
out when charging is done (approx.
1 and 1/2 hours).
3 Remove Battery
Slide Battery out and off.
Note: * Battery life gradually decreases after
After recharging 5 times, use BATTERY repeated use and recharging. If operation
REFRESH feature as explained on page 12. time becomes very short, even after a
sufficient charge, discard Battery properly ~
| 12).
Use the Battery Pack oral
A fully charged Battery provides a maximum of about 2 hours of continuous use (LCD
monitor off) or about 1.5 hours (LCD monitor on). Actual time may vary due to operating
conditions. Using the Built-in Light decreases operating time.
- 1 Attach Battery
Q Align Battery with top of mounting
surface.
© Press and snap into place.
While sliding BATTERY RELEASE,
remove Battery.
11