Setting The Clock - Sony MHC-501 Operating Instructions Manual

Insert two R6 (size AA) batteries in the
supplied remote for remote control.
1 Open the lid.
2 Insert two R6 (size AA) batteries.
Match the + and - indications to the
diagram in the battery compartment.
3 Close the lid.
Battery life
You can expect the remote to operate for
about six months (using Sony SUM-3 (NS)
batteries) before the batteries run down.
When the batteries no longer operate the
remote, replace both batteries with new
ones.
To avoid battery leakage
If you are not going to use the remote fora
long time, remove the batteries to avoid
damage caused by corrosion from battery
leakage.
Chapter 1: Setting up
Setting the Clock
The built-in clock shows the time in the
display. You need to set the clock to utilise
the timer-activated features of your stereo
system. The clock shows the time in the 24
hour cycle.
:
"To correct the clock setting
Repeat steps 1 to 5.
DISPLAY
'1 Press CLOCK SET. *
The hour indication begins flashing.
flashing
2 Set the current hour by pressing PD +
or — XJ until the correct hour appears.
flashing
3 Press ENTER/NEXT.
The minutes indication begins flashing.
flashing
4 set the current minute by pressing
Dl + or — Kd until the correct minute
appears.
flashing
5 Press ENTER/NEXT.
Use the time signal to set the clock
accurately.
"OK" appears in the display and the
clock starts.
To check the time while power is on
Press DISPLAY.
The current time appears for a few seconds.